HP Laptop Replace and Remove Memory RAM and Hard Drive HDD
Removing or Installing HDD and RAM and Battery on HP EliteBook 8470p i5 14″ on this video we’ll show you how to
1- Removing,Replacing and Installing the Battery
2- Removing,Replacing and Installing the Memory (RAM)
3- Removing,Replacing and Installing the Hard Drive (HDD)
HP EliteBook 8470p Laptop Replace and Remove Memory RAM and Hard Drive HDD
1-Removing,Replacing and Installing the Battery:
1- Position the Laptop upside-down on a flat surface, with the battery bay toward you
2- Slide the battery release latch to release the battery
3- Remove the battery from the Laptop
2- Remove the Service cover Before removing the service cover, follow these steps:
1- Turn off the Laptop. If you are unsure whether the computer is off or in Hibernation, turn the Laptop on, and then shut it down through the operating system
2- Disconnect the power from the Laptop by unplugging the power cord from the computer
3- Disconnect all external devices from the Laptop Remove the service cover:
1- Slide the release latch to disengage the door from the Laptop
2- Slide the door toward the front of the Laptop, and then lift the door off the Laptop
3- Removing,Replacing and Installing the Memory (RAM) module:
1- Spread the retaining tabs on each side of the memory module slot to release the memory module. (The edge of the module opposite the slot rises away from Laptop)
2- Remove the memory module by pulling the module away from the slot at an angle.
NOTE:
– Memory modules are designed with a notch to prevent incorrect insertion into the memory module slot.
– The Laptop uses two memory slots. The top slot houses the expansion memory module
3- Removing,Replacing and Installing the Hard Drive (HDD) Remove the Smart Card reader:
1- Use the Smart Card reader tab to lift the left side of the Smart Card reader and swing it up and to the right. Remove the hard drive: 1-Remove the three Phillips screws that secure the hard drive to the Laptop
2-Use the hard drive tab to slide the hard drive to the right to disconnect it from the system board
3- Remove the hard drive from the hard drive bay. 4- If it is necessary to disassemble the hard drive, perform the following steps:
– Remove the four PM3.0×3.0 screws that secure the hard drive bracket to the hard drive
– Remove the hard drive bracket from the hard drive
